02-25-2018, 03:21 PM
Thank you for your reply,
I noticed last night when I didn't shut the power switch off that it started fine this morning. In the past when I shut the power switch off overnight it would not start in the morning. If I turn the power switch on without starting the treadmill for about an hour it will start. I also get a "EL STL" Code when I try to incline the treadmill. The down incline works, up incline does not work. Should I try installing a new Display Cable?
We had the machine in storage for about 5 years because we moved. It worked fine before we put it in storage.
Would you have a new display cable? I thought it might have been the RPM Sensor so I was going to look for one but found out they are hard to come by. would you have one of those. I can look up the Model & Serial number for you.
Thank again
I noticed last night when I didn't shut the power switch off that it started fine this morning. In the past when I shut the power switch off overnight it would not start in the morning. If I turn the power switch on without starting the treadmill for about an hour it will start. I also get a "EL STL" Code when I try to incline the treadmill. The down incline works, up incline does not work. Should I try installing a new Display Cable?
We had the machine in storage for about 5 years because we moved. It worked fine before we put it in storage.
Would you have a new display cable? I thought it might have been the RPM Sensor so I was going to look for one but found out they are hard to come by. would you have one of those. I can look up the Model & Serial number for you.
Thank again