[rhornback]

Any suggestions for anything that isn't offered on that site?

Ie:

The weight stack bolt that attaches the pulley system to the top weight and such.

Part number 151 in the url below.

http://www.fitnessrepairparts.com/diagram/8665

Thank you for the time!

The press arm bearing for the pacific fitness is not for sale anywhere. However it is basically a flanged bearing 3/4" inside and 1 1/8" outside.

I purchased this:

http://www.ebay.com/itm/140939158663

If the listing is gone just go to ebay and search for

FLANGE WHEEL BEARING 3/8 1-1/8

This is the correct size, mine did not fit exactly so I had to use a rat tail file to remove just a 1/64 of an inch around the frame where the bearing goes in. Yours might fit without this.

My email is rhornback@hotmail.com if you have any questions.

Hope this helps someone!