+- FitnessForums (https://www.fitnessforums.net)
+-- Forum: Equipment (https://www.fitnessforums.net/Forum-Equipment)
+--- Forum: Looking for Servicer (https://www.fitnessforums.net/Forum-Looking-for-Servicer)
+---- Forum: The Northeast (https://www.fitnessforums.net/Forum-The-Northeast)
+---- Thread: Pacific Fitness - Catalina - KAT-W-CS (9G) (/Thread-Pacific-Fitness-Catalina-KAT-W-CS-9G)
Pacific Fitness - Catalina - KAT-W-CS (9G) - ken.haynes - 07-21-2015
Looking for cabling diagrams or photos of a working system
RE: Pacific Fitness - Catalina - KAT-W-CS (9G) - Timothy P. Sicard - 07-29-2016
To whom it may concern: I'm looking for a part to get my SportsArt Elliptical E820/E82 working again. The issue appears to be with the circuitry, and not a mechanical part. While using it, all of the display lights on the Console/Housing went out. The electrical outlet the machine is plugged into is working. The fuse at the rear bottom exterior of the machine is fine as is the on-light right next to it. After looking up the electrical components to this machine followed up by taking a peek inside the "wheel cover", it seems as though the problem could be with one of a few different components:
the controller (fitness repair parts.com catalog #38000080) or circuit/HTR boards (fitness repair parts.com catalog #38008010), the sensor or the transformer. I'm hoping the issue is something simple. The pedals still make a circular motion, but the console is not working to make any adjustments. We have had the machine for 9 years, but we purchased it "used". Any advice would be appreciated.
Tim
RE: Pacific Fitness - Catalina - KAT-W-CS (9G) - legioncrossfit - 05-22-2017
Hi, I am looking for the plastic , two c-cell battery holder for my Schwinn airdyne ad3. Does anyone know where I can get that battery holder? Fred
GOOD - Andrewstrauss - 07-05-2017
The issue seems, by all accounts, to be with the hardware, Can Someone Do my Coursework and not a mechanical part. While utilizing it, the greater part of the show lights on the Console/Housing went out. The electrical outlet the machine is connected to is working. The breaker at the back base outside of the machine is fine just like the on-light appropriate beside it